Brocade Communications Systems Brocade Backbone DCX 8510-4 Manual De Usuario
Brocade DCX 8510-4 Backbone Hardware Reference Manual
13
53-1002177-05
Chapter
2
Installation of the Brocade DCX 8510-4
In this chapter
•
•
•
•
•
•
•
•
Time and items required
You can set up and install the Brocade DCX 8510-4 in the following ways:
•
As a standalone unit on a flat surface.
•
In a 19-in. Electronic Industries Association (EIA) cabinet, using a Brocade DCX 8510-4,
DCX-4S Rack Mount Kit (either a 27-31 in. or 18-34 in. kit depending on rack used).
DCX-4S Rack Mount Kit (either a 27-31 in. or 18-34 in. kit depending on rack used).
•
In a chassis with the Port Side Exhaust Kit (provided) in an approved rack.
•
In a mid-mount telecommunications (Telco) rack, using the Mid-Mount Rack Kit available from
your Brocade DCX 8510-4 supplier.
your Brocade DCX 8510-4 supplier.
This chapter describes how to set up the Brocade DCX 8510-4 as a standalone unit. For
rack-mount installation instructions, refer to the appropriate manual as described in the following
table.
rack-mount installation instructions, refer to the appropriate manual as described in the following
table.
describes the main installation and setup tasks, the estimated time required for each, and
the items required to complete the task based on a fully populated Brocade DCX 8510-4 (192 Fibre
Channel ports using the FC16-48 port blades). Configurations with fewer ports require less time.
These time estimates assume a prepared installation site and appropriate power and network
connectivity.
Channel ports using the FC16-48 port blades). Configurations with fewer ports require less time.
These time estimates assume a prepared installation site and appropriate power and network
connectivity.