Bunn RT Manual De Propietario

Page 24

FIG. 24 START SWITCH - MODEL RT

FIG. 23 START SWITCH - MODEL OT

FIG. 25 START SWITCH WIRING

Location:

The start switch is located in the base, below and to 

the right of the brew station, FIG.s 23 & 24.

Test Procedure:

1.  Disconnect the brewer from the power source 

and remove the wires from both terminals of the 

start switch.

2.  Check for continuity across the two terminals on 

the switch when it is held in the lower position.  

Continuity must not be present across these 

terminals in the upper position.

If continuity is present as described, reconnect the 

wires, the switch is operating properly.

If continuity is not present as described, replace the 

switch.

Removal and Replacement:

1.  Remove all wires from the switch terminals.

2.  Compress the clips inside the housing and gently 

push the switch through the opening.

3.  Push the new switch into the opening and spread 

the clips to hold the switch captive in the hous-

ing.

4.  Refer to FIG. 25 when reconnecting the wires.

BLU to Timer P1

BLK to Indicator 

Lamp

P1687

P1688

P1697

32440 070700