Bunn FMD-2 Manual De Usuario

11

Product overflows container

Weak product

1. Dispense Switch

2. Dispense Solenoid Valve

1. Water Temperature

2. Whipper Motor

3. Frother

4. Dispense Solenoid Valve

5. Auger Drive - FMD-1

    Auger Drive - FMD-2

6. Auger Spring - FMD-1

    Auger Spring - FMD-2

7. Auger Motor - FMD-1

    Auger Motor - FMD-2

8. Rinse/Run Switch - FMD-1

    Rinse/Run Switch - FMD-2

9. Rinse Timer - FMD-2

Refer to 

Service -  Dispense Switch

for testing procedures. See page 21

Remove the solenoid valve and clear
any obstructions. Rebuild or replace
the valve if necessary. See page 34

Place an empty container beneath
the dispense tip. Initiate a dispense
cycle and check the water tempera-
ture immediately below the dispense
tip with a  thermometer.
Reading for mechanical thermostat
models should be 180

°

F to 200

°

F

(see thermostat temperature settings
decal in 

USER NOTICES on page 3.)

Refer to 

Service - Whipper Motor for

testing  procedure. See page 24

Refer to 

Service - Frother Compo-

nents. See page 24

Refer to 

Service - Dispense Solenoid

Valve for test procedures. See page
34

Refer to 

Service - Auger Drive Com-

ponents. See page 13
See page 15

Refer to 

Service - Auger Drive Com-

ponents. See page 13
See page 15

Refer to 

Service - Auger Drive Com-

ponents. See page 13
See page 15

Refer to 

Service - Rinse/Run Switch

for test procedures. See page 31
See page 32

Refer to 

Operation - Rinse Timer.

See Page 5

29112 101598