Bunn VLPF Manual De Propietario

Page 26                                    

FIG. 22 START SWITCH

P2172.80

BLU to Timer

WHI/ RED to On/ Left Switch

WHI/ RED to Liquid Level 

Control Board

P1987

FIG. 23 START SWITCH TERMINAL

10179 060100

Location:

  The Start switch is located in front of the hood, 

centered above the brew funnel.

Test Procedure:

1.  Disconnect the brewer from the power source and 

remove the wires from both terminals of the Start 

switch.

2.  Check for continuity across the two terminals on 

the switch when it is held in the lower position. 

Continuity must not be present across these ter-

minals in the upper position.

If continuity is present as described, reconnect the 

wires, the switch is operating properly. (It does not 

matter which terminals the wires are installed on).

If continuity is not present as described, replace the 

switch.

Removal and Replacement:

1.  Remove all wires from the switch terminals.

2.  Compress the clips inside the hood and gently 

push the switch through the opening.

3.  Push the new switch into the opening and spread 

the clips to hold the switch captive in the hood.

4.  Refer to the FIG 23. When reconnecting the 

wires.