Bunn VLPF Manual De Propietario

Page 4                                    

CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up.

 

The brewer has an attached cordset and requires 2-wire, grounded service rated 120 volts ac, 15 amp, single 

phase, 60 Hz.

  This brewer must be connected to a cold water system with operating pressure between 20(138) and 90 

psi(620 kPa) from a 1/2” or larger supply line.  A shut-off valve should be installed in the line before the brewer.  

Install a regulator in the line when pressure is greater than 90 psi(620 kPa) to reduce it to 50 psi(345 kPa).  The 

water inlet fitting is 1/4” flare.

NOTE - Bunn-O-Matic recommends 1/4” copper tubing for installations of less than 25 feet and 3/8” for more 

than 25 feet from the 1/2” water supply line.  A tight coil of copper tubing in the water line will facilitate moving 

the brewer to clean the counter top.  Bunn-O-Matic does not recommend the use of a saddle valve to install the 

brewer.  The size and shape of the hole made in the supply line by this type of device may restrict water flow.

 

Placing the switch in the upper position supplies power to the left decanter warmer and enables brewing and 

refilling of the tank.  Placing the switch in the lower position cuts power to the left decanter warmer and stops 

brewing and refilling of the  tank.  Stopping a brew cycle after it has been started will not stop the flow of water 

into the funnel until the tank syphons down to its proper level.

NOTE -  The On/Left switch must be in the upper position to initiate and complete a brew cycle or to automatically 

refill the tank after using the hot water faucet.

Starts a brew cycle when the On/Left switch is in the upper position.

Placing the switch in the upper position supplies power to the right decanter warmer.  Placing the switch in 

the lower position cuts power to the right decanter warmer.

10179 051712