Bunn Ultra-2 Manual De Usuario

17

1.  Install the seal(s) over the flange at 

the rear of the cooling drum(s) and 

press the seal(s) firmly into place 

as shown.

2.  Align the auger shaft(s) with the 

auger(s). Push the auger(s) as far as 

they will go and rotate so the flat face 

of the auger shaft is aligned with the 

flat face of the auger nose.

4.  Thoroughly rinse the hopper(s) 

and install over the auger(s) and 

cooling drum(s).

6.  Set the lids on the hopper(s) 

and plug in the hopper lid lamp 

cord(s).

10. Assemble the drip tray.

8.  Slide the faucet valve assembly into 

place on the hopper.

9.  Press down on the valve to com-

press the spring. Position the faucet 

handle over the faucet valve one 

side at a time and snap into place 

on the hopper.

7.  Position the faucet seal and return 

spring in the faucet valve.

5.  Slide into place and push down until 

the hopper lock plunger(s) snap 

into place. On models with autofill, 

reconnect fill hoses and level probe 

to hopper.

3.  Install auger nose bushing into 

inside front of hopper.

11. Turn ON augers and cooling function 

to desired settings.

45246 072611