Harbor Freight Tools 7 in. 1.5 HP Bridge Wet Cut Tile Saw with Stand Manual Del Producto

Page 15

Item 60608 

        

Tool will not start. 1.  Cord not connected.

2.  No power at outlet. 

 

 

3.  Tool’s circuit breaker tripped. 

4.  Internal damage or wear.  (Carbon 

brushes or switch, for example.)

1.  Check that cord is plugged in.
2.  Check power at outlet.  If outlet is unpowered, 

turn off tool and check circuit breaker.  

If breaker is tripped, make sure circuit is right 

capacity for tool and circuit has no other loads.

3.  Turn off tool and wait approximately 5 minutes.  

Press circuit breaker button on tool.

4.  Have technician service tool.

Tool operates 

slowly.

Extension cord too long or 

wire size too small.

Eliminate use of extension cord.  

If an extension cord is needed, use shorter/

heavier gauge cord.  See Table A on page 3.

Performance 

decreases 

over time.

1.  Blade dull or damaged.
2.  Carbon brushes worn or damaged.

1.  Keep cutting accessories sharp.  Replace as needed.
2.  Have qualified technician replace brushes.

Excessive noise 

or rattling.

Internal damage or wear.  (Carbon 

brushes or bearings, for example.)

Have technician service tool.

Overheating.

1.  Forcing machine to work too fast.
2.  Blade misaligned.
3.  Blade dull or damaged.
4.  Motor being strained by long or 

small diameter extension cord.

1.  Allow machine to work at its own rate.
2.  Check and correct blade alignment to fence and table.
3.  Keep cutting blades sharp.  Replace as needed.
4.  Eliminate use of extension cord.  

If an extension cord is needed, use shorter/

heavier gauge cord.  See Table A on page 3.