Bunn Single SH Manual De Propietario

Page 7

28230 121207

 

Momentarily pressing and releasing this switch starts a brew cycle when the On/Off switch is in the lighted 

upper position.

NOTE: The On/Off switch must be in the lighted upper position to initiate and complete a brew cycle. 

  Placing the switch in the unlighted lower position cuts power to the timer and stops brewing.  Stopping a 

brew cycle after it has been started will not stop the flow of water from the funnel.  Placing the switch in the 

lighted upper position supplies power to the timer and enables the brew circuit. 

 

Placing the switch in the 1/2 gallon, 1 gallon, 1-1/2 or 1-3/4 gallon position selects the amount of coffee to 

be brewed in subsequent brew cycles.  Repositioning this switch after a brew cycle has been initiated does 

not change the brew batch in progress.

1.  Select the desired batch size.

2.  Insert a BUNN filter into the funnel.

3.  Pour the proper amount of fresh coffee into the filter and level the bed of grounds by gently shaking.

4.  Slide the funnel into the funnel rails.

5.  Place an empty server under the funnel.

6  Place the On/Off switch in the lighted upper position.  Momentarily press and release the start switch.

7.  When brewing is completed, simply discard the grounds and filter.

1.  The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all 

surfaces on Bunn-O-Matic equipment.

2.  Remove and clean the sprayhead. Use the pointed end of sprayhead cleaning tool (#38227.0000) to remove 

any mineral deposits from the sprayhead holes.

3.  Insert the long end of sprayhead cleaning tool into the sprayhead fitting, and rotate several times to remove 

any mineral deposits from the fitting.

4.  Insert the short end of sprayhead cleaning tool into the bypass fitting, and rotate several times to remove 

any mineral deposits from the fitting.

NOTE: In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer 

and takes less than a minute.