Bunn FMD-4 Manual De Usuario

26

J4

J1

J2

J3

J4

J1

J2

J3

FIG. 17 FROTHER AND WHIPPER MOTOR

Location:

The frothers are located behind the dispenser door,

mounted on the front panel inside the whipper cham-
ber.

The whipper motors are located on the back side

of the whipper motor mounting panel.

Test Procedure:
1. Disconnect the dispenser from the power source.
2. Disconnect the red and white wires (FMD-1 &

FMD-2 left motor) or orange and white wires
(FMD-2 right motor) of the main harness from the
black leads of the motor.

3. Press and hold the  dispense switch and check the

voltage across the disconnected harness wires
with a voltmeter. Connect the dispenser to the
power source. The reading must be:
a) 120 volts ac for two wire 120 volt models.
b) 120 volts ac for three wire 120/208 volt or 120/
240 volt models.

4.  Disconnect the dispenser from the power source.

If voltage is present as described, replace the motor.
If voltage is not present as described, refer to the wir-
ing diagrams and check the dispenser wiring harness.

FIG. 18 MIXING/WHIPPER CHAMBER

COMPONENTS

1.

Steam Collector

2.

Mixing Chamber

3.

Dispense Tip

4.

Whipper Chamber

5.

O-Ring

6.

Frother

7.

Receptacle w/Seal

8.

Nut

9.

Slinger

10. Motor Assy.
11. Fan
12. Vacuum Hose
13. Baffle

P2635

P2628

10

1

2

4

3

9    8    6   5

7

11  12      13

Removal, Cleaning & Replacement (Refer to Fig. 18):
1. Open the dispenser door and raise the top front

cover.

2. Lift the front edge of the each hopper assembly

over the tab on the hopper support panel and
slide each hopper assembly out the front of the
dispenser. Set aside for reassembly.

3. Remove the four #8-32 screws securing the hop-

per support panel to auger motor mounting panel
and the whipper motor mounting panel. Set aside
for reassembly.

35135 012103