Bunn Dual SH DBC (/5, 1/0 gal) Manual De Propietario

Page 7

29877.5 020413

CAUTION: The brewer must be disconnected from the power source throughout the initial setup, except when 

specified in the instructions.

1.  Insert an empty funnel into the funnel rails of one of the 

brew stations.

2.  Place an empty server under the funnel.

3.  Connect the brewer to the power source. Main ON/OFF 

Switch (located in bottom cover behind right front leg on 

some brewers) must be in the ON position. Water will begin 

flowing into the tank and stop when the tank is filled to its 

capacity. Display will show PLEASE WAIT...TANK FILLING 

until tank is filled with water.

4.  Wait approximately twenty minutes for the water in the 

tank to heat to the proper temperature. Display will show 

READY TO BREW...WATER TEMP: XXX˚ when tank is at 

operating temperature.

 

NOTE: Brew water temperature is factory set at 200° F 

(93.3° C). Refer to TEMPERATURE SELECTION  below 

should the water temperature need to be increased or 

decreased. When brew water temperature is changed, 

ready temperature should be increased or decreased ac-

cordingly.

5.  Place a small vessel beneath the faucet and open the faucet 

handle. Release it when you hear the tank refilling.

6.  Water volumes have been preset at the factory. Refer 

to adjustments for the Set Brew Volumes section of the 

Programming Manual on the Bunn-O-Matic website, at 

www.bunn.com should the volume need to be increased or decreased.

7.  The brewer is now ready for use in accordance with the coffee brewing instructions.

  This function allows the operator to set the brew water temperature in the tank.  It also sets the hot water 

faucet dispense temperature.

1.  Press and hold upper right hidden switch until the display reads SELECT RECIPE. Release switch.  Continue 

to press and release switch until the display reads  SET TEMP.

2.  To adjust the brew temperature, press (-) to decrease or (+) to increase the brew temperature.

3.  When finished, press and release DONE to save the new setting, exit the SET TEMP function and advance to 

the next function screen,  SET READY. Another alternative is to press and release  the ON/OFF switch (either 

on DUAL brewers) located on the front switch panel to exit the SET TEMP function and return to the MAIN 

°

°

°

°

SET TEMP: XXX°

 (-)  DONE  (+)