Bunn 10 Cup Pourover Coffee Brewer A10 Manual De Usuario
7
CAUTION - Do not plug-in the brewer until specified in Initial
Set-Up.
The A10/A10 Automatic Brewer has an attached cordset and
requires 2-wire grounded service rated 120 volts ac, 10 amp,
single phase, 60 Hz.
The A10A/A10A Automatic Brewer has an IEC 320 connector
and matching cordset and requires 2-wire grounded service rated
230 volts ac, 10 amp, single phase, 50-60 Hz. The appropriate
cordset connector must be supplied when installing the brewer.
CONTINUED
PLUMBING REQUIREMENTS - A10 AUTOMATIC ONLY
This brewer must be connected to a cold water system with operating pressure between 20 and 90
psi from a 1/2” or larger supply line. A shut-off valve should be installed in the line before the brewer.
Install a regulator in the line when pressure is greater than 90 psi to reduce it to 50 psi. The water inlet
fitting is 1/4” flare.
NOTE – Bunn-O-Matic recommends
1
/
4
” copper tubing for installations of less than 25 feet and
3
/
8
” for more
than 25 feet from the
1
/
2
” water supply line. At least 18 inches of an FDA approved flexible beverage tubing,
such as reinforced braided polyethylene or silicone, before the brewer will facilitate movement to clean the
countertop. It can be purchased direct from Bunn-O-Matic (part number 00326-0000).
As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of
the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow prevention to
comply with federal, state and local codes. For models installed outside the U.S.A., you must comply with the
applicable Plumbing /Sanitation Code for your area.
Plumbing Hook-Up
1. Attach the flare fitting from the short piece of tubing on the flow control (supplied) to the water inlet
1. Attach the flare fitting from the short piece of tubing on the flow control (supplied) to the water inlet
fitting on the left rear side of the brewer.
2. Flush the water line and securely attach it to the flare fitting on the strainer.
3. Turn on the water supply.
3. Turn on the water supply.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specified in conformance with all local and national
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specified in conformance with all local and national
codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given instructions
concerning use of this appliance by a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service
• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service
personnel with a special cord available from the manufacturer or its authorized service personnel in
order to avoid a hazard.
• Machine must not be immersed for cleaning.
ELECTRICAL REQUIREMENTS
120 VOLT
230 VOLT CE
43422.1 010311