Bunn 1 GPR, 1/5 GPR, 1/75 GPRCanada Manual De Propietario

Page 8

FIG. 3 CONTROL THERMOSTAT 

 

This section provides procedures for testing 

and replacing various major components used in 

this brewer should service become necessary.  Refer 

to Troubleshooting for assistance in determining the 

cause of any problem.
WARNING - Inspection, testing, and repair of electri-

cal equipment should be performed only by qualified 

service personnel.  The brewer should be disconnected 

from the power source  when servicing, except when 

electrical tests are required and the test procedure 

specifically states to plug-in the brewer.
COMPONENT ACCESS
WARNING - Disconnect the brewer from the power 

source before the removal of any panel or the replace-

ment of any component.

  All components are accessible by the removal of 

the top cover and fill basin.
  The top cover is attached with two #4-40 

screws.

   

 

Control Thermostat ................................................9

Limit Thermostat ..................................................10

Tank Heater ......................................................... 10 

Wiring Diagrams ................................................. 12

P2412-1

  The tank inlet fitting secures the fill basin to the 

tank lid

.

P2413

FIG. 2 FILL BASIN REMOVAL

FIG. 1 COMPONENT ACCESS

P2414

39064 042806