Bulldog Security 1402 Manual De Usuario

6. Use electrical tape to wrap. Be sure to cover the wire about two

inches on either side of the connection. First pull the wire that you

have just connected along side the wire you connected to, tape and

wire tie them together. Use this method for all connections.

CAUTION: All wires must be wrapped with tape and wire

tied.

5. Wrap the wire around one side then the other and finally around

itself as shown.

Wire Tie

Electrical Tape

MAKING CONNECTIONS

CONT.

2. Twist upper wires together, twist lower wires together as shown.

1. When tying two separate wires together at their ends, strip back 1

of insulation on both wires and separate the strands of wire as shown

below.

MAKING END TO END CONNECTIONS

FOLLOW THESE INSTRUCTIONS

MAKING CONNECTIONS

CONT.

4. Use electrical tape to wrap, be sure to cover about 2 inches on either

side of connection. Secure with wire ties as shown.

3. Lay upper twisted pair of wires

over right wire as shown. Bring

lower twisted pair of wires up

to meet the left wire as shown.

Use this method ONLY when connecting two separate wires end to end.

LOCATING & MAKING

CONNECTIONS

CONSTANT POWER (+12V, key in any position including off)

This system operates on constant 12 volts, the system also needs a source

of power that is only on when the ignition is turned on (usually referred

to as Ignition Power.

1. Locate the wires going to your vehicles ignition switch (usually located

coming down the steering column). When looking for constant 12 volts:

Usually a large gauge wire located at the ignition switch harness. Probe

these wires until you find one that turns a computer-friendly test light,

or shows 12 volts when the ignition switch is turned to the ON, OFF,

START and ACCESSORY positions. If this wire cannot be located at the

ignition switch harness, run at least a 16 gauge wire from the positive

battery terminal fused at 6 inches from the positive battery post to the

inside of the vehicle through the firewall. (Additional hardware is needed.)

2. Mark this with its function Constant Power.

Wire Ties

Electrical Tape