Black Box Switch PQ-8P Manual De Usuario

2. Install the correct paper size into

the printer.

3. Power the printer off for about

five seconds, then power it back
on again.

4. Release the job for printing at

the printer’s controlling
workstation.

The line format screens in

DisplayWrite/36 (Command 20)
also permit you to select “Justify,”
which aligns the right margin. The
PQ-8 supports justification for fixed
fonts only. For best results using
justification, change the zone width
to 1 (instead of 6).

Some printers, such as the HP
LaserJet 4V printer, allow printing
on 11" x 17" and A3 size paper. The
PQ-8 automatically recognizes these
larger paper sizes. However, at times
it might be advantageous to force
the printer to print on 11 x 17 inch
or A3 size paper, even when the host
sends requests for smaller paper
sizes (letter, legal, A4, Executive).  If
this is desired, the PQ-8’s 11 x 17
(A3) selection should be turned ON
through Host/PC download
command 32 or through the setup
software.

With this selection turned ON, the

PQ-8 will request the printer to load
A3 size paper when the host requests

A4 or A3, and 11 x 17 inch paper in
all other cases. In addition, the PQ-
8’s APO feature (if turned ON) will
automatically rotate all
documents/reports with dimensions
of 11 x 17 inches or smaller. To
achieve COR in this case, the
document/report has to be larger
than 11 x 17 inches.

OfficeVision/400 and
DisplayWrite/36 allow the user to
direct the print output to one of
several paper sources regardless of
whether the printer actually has 1, 2,
3 or more trays to pull paper from.
On the host, several of these
theoretical paper sources are called
paper drawers. On the printer, the
actual paper sources are usually
called trays. The PQ-8 acts as the
matchmaker between theoretical
paper drawers and physical trays
available on the printer.

The paper-drawer feature of the

PQ-8 can be accessed through
Host/PC download commands 13,
14, and 15 or through the setup
software.