Bionaire BFH3414 Manual De Usuario

For maximum heat distribution use the oscillation function.

1. Press the Oscillation button on the remote control to

begin 90° oscillation.

2. To stop the heater from oscillating, press the Oscillation 

button a second time; the unit will stop in that direction.
To resume oscillation, press the Oscillation button again.

Note:  The oscillation feature can only be operated from 
the Remote Control.

DO NOT attempt to turn oscillation by hand.  
Severe damage to the mechanism could result.  

Before cleaning make sure the unit is unplugged. 
1. Allow the heater to cool before cleaning. 
2. Carefully wipe the unit with a soft, damp cloth.
3. Please be cautious near the heating elements.  

☛

TIP: Over time, dust may accumulate on the front grills. 
This can be removed by wiping the unit with a damp
cloth. Always unplug unit and allow to cool prior to
cleaning.

Store heater in a cool, dry location. Bionaire

®

recommends

storing the unit in its original, or appropriately sized, box. 

☛

✔

Make sure the electrical outlet or circuit breaker is working. 

✔

Check for obstructions. If you find an obstruction turn 
the heater OFF, and follow the Reset Instructions in the
manual. Carefully remove the obstruction. 

✔

The thermostat might be set too low. Adjust the 
thermostat until the heater restarts. 

To take advantage of the SmartTouch

™

Thermostat 

continue to press the MODE/OFF button until the desired
temperature is set in either the HIGH (1500 Watt) or LOW
(750 Watt) setting.  When ambient temperature rises
above the set temperature, the heater will stop.  
When the ambient temperature drops below the set 
temperature, the heater will turn on automatically.

Note:  When the SmartTouch

™

thermostat is set, either

the HIGH or LOW power light, and the set temperature
light will remain lit during operation. 

Note:  It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to raise the thermostat setting.

Note:  SmartTouch

™

has memory. The SmartTouch

™

thermostat will remember the previous temperature 
setting after the unit has been turned off.  However, 
if the unit is unplugged, the SmartTouch

™

thermostat 

will be reset and will no longer remember the previous
temperature setting.

1. Before operation, insert 2 AAA batteries into the back 

of the remote control.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zine), or 

rechargeable (nickel-cadmium) batteries.

2. Press the power button (    ) on the remote control to  

begin operation.  Press the button a second time to 
turn the heater off.  

3. To change the heat or thermostat settings, press the

mode button.  The mode button will scroll through the
two heat settings, then switch into Auto mode so that 
the thermostat can be adjusted.  Once in Auto mode,
continue to press the mode button until the desired 
temperature setting is reached.

BFH3414/BFH3416 printer ver.qxd  6/14/02  2:45 PM  Page 5