Benq PB8260 Manual De Usuario
Operation
19
Operation
Start up
1.
Switch all of the connected equipment on.
2.
Plug the power cord into the projector and into a wall
socket. Turn on the power point (if switched).
socket. Turn on the power point (if switched).
3.
Turn the main power switch on. The Power indicator
lights orange.
lights orange.
4.
Remove the lens cap. If it is left on, it could become
deformed due to heat.
deformed due to heat.
5.
Press and hold (for 2 seconds) the Power button on
the remote control or projector to start the unit.
The Power indicator light flashes green when the
unit is on.
the remote control or projector to start the unit.
The Power indicator light flashes green when the
unit is on.
6.
The start up procedure takes about 30 seconds
after pressing Power. In the later stage of start up, a
default BenQ logo is projected.
after pressing Power. In the later stage of start up, a
default BenQ logo is projected.
7.
Next, a projector boot screen displays as below. If
the supplied BenQ wireless card is installed in the
projector and its indicator lights green, set up your
laptop or desktop later by using the information
shown on the page like Network ID (SSID), Network Type, and IP Address.
the supplied BenQ wireless card is installed in the
projector and its indicator lights green, set up your
laptop or desktop later by using the information
shown on the page like Network ID (SSID), Network Type, and IP Address.
Projector Selector page on your
computer
2
3
3
4
1
Projector boot screen
2
3
4
3
4
1