Brother 882-W07 Manual De Usuario
SEWING THE STITCHES
U
tili
ty
ty
S
tit
ch
es
129
3
c
Attach presser foot “J”. Align the center of
the presser foot with the middle of the
space between the fabrics and begin
sewing.
space between the fabrics and begin
sewing.
a Basting stitches
d
When sewing is finished, gently tear the
paper away.
paper away.
Tape or Elastic Attaching
a
Select a straight stitch and attach presser
foot “J”.
foot “J”.
b
Set the stitch length to 4.0 mm (approx.
3/16 inch), and loosen the upper thread
tension to 2.0 (see “Setting the Stitch
Length” on page 79 and “Setting the Thread
Tension” on page 79).
3/16 inch), and loosen the upper thread
tension to 2.0 (see “Setting the Stitch
Length” on page 79 and “Setting the Thread
Tension” on page 79).
c
Sew two rows of straight stitches on the
right side of the fabric, then pull the bobbin
thread to create the necessary gather.
right side of the fabric, then pull the bobbin
thread to create the necessary gather.
d
Place the tape over the gather, and hold it
in place with basting pins.
in place with basting pins.
a Tape
e
Select
or .
f
Sew over the tape (or elastic).
Memo
• Use a thick thread.
Memo
• Be sure that neither automatic reinforcement
nor automatic thread cutting
is
selected.
Memo
• Before sewing the straight stitch, rotate the
handwheel toward you (counterclockwise)
and pull up the bobbin thread. Holding the
top and bobbin thread, pull a length of
thread out from the rear of the machine. (Be
sure that the presser foot is raised.)
and pull up the bobbin thread. Holding the
top and bobbin thread, pull a length of
thread out from the rear of the machine. (Be
sure that the presser foot is raised.)
Memo
• For details on each stitch, refer to the
“STITCH SETTING CHART” at the end of
this manual.
this manual.
CAUTION
• Be sure the needle does not strike a basting
pin, or any other objects, during sewing. The
thread could tangle or the needle could break,
causing injury.
thread could tangle or the needle could break,
causing injury.