Brother 285 Manual De Usuario
9
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Needle and embroidery foot section
a Thread guide disk
Pass the thread through the thread guide disk when
using the needle threader to thread the needle.
using the needle threader to thread the needle.
b Needle bar thread guide
Pass the upper thread through the needle bar thread
guide.
guide.
c Needle plate
When the needle is lowered, it enters the hole in the
needle plate.
needle plate.
d Needle plate cover
Remove the needle plate cover to clean the bobbin case
and race.
and race.
e Bobbin cover/bobbin case
Remove the bobbin cover, and then insert the bobbin
into the bobbin case.
into the bobbin case.
f Embroidery foot “Q”
This presser foot is used for embroidering.
Right-side/rear view
a Handle
Carry the machine by its handle when transporting the
machine.
machine.
b Handwheel
Turn the handwheel toward you (counterclockwise) to
raise and lower the needle.
raise and lower the needle.
c Embroidery card slot
Insert the embroidery card.
d Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the
machine is being used.
exchanged. Do not cover the air vent while the
machine is being used.
e Power supply jack
Insert the plug on the power supply cord into the power
supply jack.
supply jack.
f Main power switch
Use the main power switch to turn the machine on and
off.
off.
Memo
z Refer to pages 8 through 11 while you are
learning to use your machine.