Genesis Advanced Technologies 2002 Manual De Usuario
when filled with water. Do not drop the bath on a hard
surface.
GENESIS
GENESIS
2006
: Remove all, or part of the water. The bath
weighs approximately thirty (30) pounds when filled with
water. Carefully remove the water bath from the device.
water. Carefully remove the water bath from the device.
5.6 DO NOT USE BLEACH OR HARSH CLEANERS.
Depending on mineral content of water used, the bath may
discolor. Proper cleansing should keep this to a minimum.
Use LABath CLEAN
discolor. Proper cleansing should keep this to a minimum.
Use LABath CLEAN
TM
regularly to control bacteria, algae
and turbidity. To order additional LABath CLEAN
TM
, call
GenesisBPS, LLC
at 866-712-5663.
5.7 Fill the bath. The maximum water level should be
approximately two inches from the top of the water bath.
This level will ensure that the water level will be at the
slotted line on the unit when the bath is repositioned.
This level will ensure that the water level will be at the
slotted line on the unit when the bath is repositioned.
DON'T OVERFILL THE BATH. Add 2 ml of LABath
CLEAN
TM
each time water is changed.
DON'T USE BLEACH OR HARSH CLEANERS as this may
scratch and discolor bath.
5.8 To replace bath: GENTLY place the bath onto the ROCKER
PIN, ensure the pin head is located in the slot of the bath.
Ensure that the center of bath is positioned onto the white
roller on the base plate. Hold the handle firmly on the front of
the control panel. Release the clamp knob by turning it
counterclockwise. Lower the unit slowly into the water.
Ensure that the center of bath is positioned onto the white
roller on the base plate. Hold the handle firmly on the front of
the control panel. Release the clamp knob by turning it
counterclockwise. Lower the unit slowly into the water.
11