Behringer Guitar Link UCG102 Instruccion De Instalación
8
GUITAR LINK UCG102 Software Installation Guide
2.2 Installing the guitar combos software
The Guitar Combos software consists of three different combos.
Choose any or all of them for installation. With the serial number on
the CD sleeve you can fully activate one combo. For details, refer to the
imprint on the CD sleeve. All other combos can be run in demo mode
with the following restrictions:
• Saving of sounds is disabled
• Quits after 30 minutes
• Total recall is disabled
Choose any or all of them for installation. With the serial number on
the CD sleeve you can fully activate one combo. For details, refer to the
imprint on the CD sleeve. All other combos can be run in demo mode
with the following restrictions:
• Saving of sounds is disabled
• Quits after 30 minutes
• Total recall is disabled
To install a combo on your system,
proceed as follows:
1) From the folder “NI Guitar Combos“ on your CD, choose the
proceed as follows:
1) From the folder “NI Guitar Combos“ on your CD, choose the
combo you wish to install and open the respective archive file
(ZIP) by double-clicking on its entry.
(ZIP) by double-clicking on its entry.
2) Double-click on “Setup.exe“ to start the installation.
3) Follow the on-screen instructions.
3) Follow the on-screen instructions.
If you have the serial number for the installed combo:
4) Accept to start the NI Service Center, by checking the
4) Accept to start the NI Service Center, by checking the
respective entry.
◊ If your computer is not connected to the internet, choose the
offline registration method to activate the combo via
another computer.
another computer.