Brother HL-4040CN Manual De Propietario
Troubleshooting
144
7
LCD messages
7
If any problems occur, the printer automatically stops printing, diagnoses the problem, and displays the
resulting message on the LCD to alert you. Take the appropriate action, referring to the following tables. If
you cannot clear the problem, call the dealer you bought the printer from or Brother Customer Service.
resulting message on the LCD to alert you. Take the appropriate action, referring to the following tables. If
you cannot clear the problem, call the dealer you bought the printer from or Brother Customer Service.
Note
The LCD names for the paper trays are as follows.
• Standard paper tray: Tray1
• Multi-purpose tray: MP
• Optional Lower tray(HL-4050CDN / HL-4070CDW only): Tray2
Error messages
Error message
Action
Access Error
The USB device was removed while data was processing. Press Cancel. Reinsert the USB
device and try to print with Direct Print or PictBridge.
device and try to print with Direct Print or PictBridge.
Cartridge Error
Pull out the drum unit. Take out the toner cartridge that is indicated on the second line of
LCD and put it back into the printer again.
LCD and put it back into the printer again.
Cover is Open
Close the cover that is indicated on the second line of LCD.
DIMM Error
Turn off the printer. Re-install the DIMM correctly. Wait a few seconds, and then turn it on
again. If this error message appears again, replace the DIMM with a new one. See Installing
extra memory on page 95.
again. If this error message appears again, replace the DIMM with a new one. See Installing
extra memory on page 95.
Drum Error
Clean the corona wires. (See Cleaning the corona wires on page 128.)
EL Error
Open the front cover and close it again.
Fuser Error
Turn the power switch off, wait a few seconds and then turn it again. Leave the printer for
15 minutes with the power on.
15 minutes with the power on.
Jam XXX
Carefully pull out the jammed paper from the area shown in Paper jams and how to clear
them on page 148.
them on page 148.
Low Temperature
Allow the machine to warm up.
Manual Feed
Put the same size of paper in the MP tray as is shown on the LCD. If the printer is 'paused',
press Go.
press Go.
No Belt Unit
Install the belt unit. (See Belt unit on page 112.)
No Drum Unit
Install the drum unit. (See Drum unit on page 106)
No Paper
Put paper in the indicated empty tray.
No Tray
Put the tray1 in the printer.
No Waste Toner
Install the Waste Toner Box. (See Waste toner box on page 117.)
Out Of Memory
Add more memory. (See Installing extra memory on page 95.)
Size Error
Check the printer driver setting and put the correct sized paper in tray that is indicated on
the second line of LCD. (See About paper on page 6.)
the second line of LCD. (See About paper on page 6.)
Size Error DX
You can only use Letter, Legal or Folio size for duplex printing. Check the printer driver
setting. Put the correct size of paper, which is indicated on the second line of the LCD, in
the tray. (See About paper on page 6.)
setting. Put the correct size of paper, which is indicated on the second line of the LCD, in
the tray. (See About paper on page 6.)