Bakers Pride Fry Warmer HFW Manual De Usuario

 

 

Serious injury, equipment damage or death could result if attempting to install this unit 
yourself. Ensure that an authorized BKI service agent install the oven. 

You are responsible for filing all freight claims with the delivering truck line. Inspect all cartons and crates for 
damage when they arrive. If there is damage noted to shipping crates or cartons, or, if a shortage is found, note 
this on the bill of lading (all copies) before signing. 
 
If damage is detected when the equipment is uncrated, immediately call the delivering truck line and follow up the 
call with a written report indicating concealed damage to your equipment. Ask for an immediate inspection of your 
concealed damage item. Crating material MUST be retained to show the inspector from the truck line. 

 

 

Electrocution, equipment failure or property damage could result if an unlicensed 
electrician performs the electrical installation. Ensure that a licensed electrician perform 
the electrical installation in accordance with local codes, or in the absence of local codes, 
with the National Electrical Code, ANSI NFPA 70-20XX. 

 
HFW’s are wired for use in accordance with all applicable local, state, and federal codes. For specific electrical 
requirements and connections refer to the wiring diagram attached to the unit or provided in the Service Manual. 

 

If a side or back panel is removed on the chute, the other two sides must be sealed with 
NSF approved silicone. Seal all inside seams greater than 1/32”. 

 

1.  Obtain a suitable countertop location for the unit that will provide a clearance of 4” from the rear louvers.  

 

2.  Plug unit into 20 amp, 120 volt recepticle.