Balcar R410A Manual De Usuario

–

 170 

–

216

110

27.5

76

320

170

70

50

130

130

120

27.5

200

320

170

160

100

450

450

55

97

160

323

155

90

109

27.5

Power cable port
(Ø40 knockout)

Knockout hole for upper 
piping of indoor unit

Opening hole on ceiling
(Ø100, 2 positions)

Check port

Drain pipe

Refrigerant pipe 
at liquid side
(Elbow type pipe kit)

Refrigerant pipe 
at gas side
(Elbow piping kit)

Flexible hose of drain pipe
(Attached to drain up kit)

Refrigerant pipe 
(Elbow piping kit)

Drain up kit

• In the installation work of the drain up kit, the pipe cannot be draw out from other side than the upper side.

• Apply thermal insulation for all the drain pipes.

• Open two opening holes (Ø100, 2 positions) on the ceiling surface to be installed in order to pass refrigerant pipe

and drain pipe.

• Set a 450-square check port on the ceiling surface to be installed.

Slide the suction grille fixing knobs (2 positions)
toward the arrow direction, and then open the
suction grille.

Under the condition of suction grille opened, push
the hook section of hinges (2 positions) at the rear
side, and then pull out the suction grille.

After removing the side panel fixing screws (1 each
at right and left), slide the side panel forward and
then remove it.

Peel out the protective vinyl on the level flap.

Remove the protectors (2 pcs.) of the fan.
(RAV-SM801CT only)

Suction grille

Pull out suction grille 
while pushing hook.

Suction grille 
fixing knob

Hinge

Slide

Slide forward.

Side panel

Level flap

Protector

Open the draw-out port (Knockout hole) at upper side.

Connect “ELBOW PIPING KIT” sold separately to the
indoor unit.

Draw-out port 
at upper side
(Knockout hole)

Elbow type pipe 
at gas side

Elbow type pipe 
at liquid side

Draw-out port 
at upper side