Emerson Liebert iCOM Manual De Usuario

This screen is shown when rack sensors have been configured for control or reference. The 

temperatures at the top of the main unit screen are based on which sensors are used for controlling 

airflow, cooling capacity and humidification.
The data at the upper left of the screen can be either average or maximum rack temperature, 

depending on the selection in the Remote Sensors Mode. The data at the upper middle of the screen 

can be either dew point or relative humidity, depending on humidity control type.
Each unit can display individual remote rack sensor readings. The readings will be either an average 

or maximum reading between the two sensors connected at each 2T sensor module.
The bar graph’s upper limit is set at 77°F (25.0°C). The lower limit is set at 68°F (20°C), the rack inlet 

temperature range recommended by ASHRAE. When a rack temperature is at or above the upper 

limit, the bar graph will be all black. When a rack temperature is at or below the lower limit, the bar 

graph will be all white.

Liebert iCOM shows icons and text for monitoring and controlling your Liebert cooling units or 

network of cooling units. The number of icons and amount of text shown depends on the display size.
The Liebert iCOM has three main menus; User, Service and Advanced.
The User menu contains the most frequently used features, settings and status information. The 

Service menu contains settings and features used to set up unit communications and for unit 

maintenance. The Advanced menu contains settings used to set up the unit at the factory. Do not 

attempt to make any changes in the Advanced menu without consulting the factory first.