Bühler FK303 Manual De Usuario

                                           

        25 Series Rotary Tiller 

 

 

-23- 

 

 
A shear pin is provided in the input drive shaft at the gearbox to protect the drive system 
during an overload.  To change the shear pin, follow this procedure: 
 
1.   

Place all controls in neutral, stop engine, set park brake, remove ignition key and 
wait for all moving parts to stop before dismounting. 

 
2.   

Disconnect the PTO shaft from the tractor and lay to the side. 

 
3.   

Carefully remove remaining shear bolt using a hammer and punch if necessary.  
Be careful not to enlarge the holes. 

 
4.  

Install the new shear bolt and tighten.  (6mm & 40mm, Gr.5) 

 

ALERT:   Use only genuine Buhler Farm King parts.  These shear bolts 
are specially designed to provide protection for the drive system.  Do not 

  install just any bolt. 

 

 
 
During normal operation, the slip clutch can release and slip when encountering an 
obstruction or when overloaded.  It is designed to slip when the load exceeds 3 times its 
nominal rating.  When the clutch slips too frequently during normal operating conditions, 
it is necessary to replace the clutch linings.  NOTE:  The PTO shafts are shipped with 
the slip clutch disengaged.  There are four socket set screws on the inside of the clutch 
assembly, which are turned out as far as they go to engage the clutch.  Disengage 
clutch by turning set screws in fully. 
 
To replace clutch linings, follow this procedure:        
 
1.   

Disengage the clutch by turning the four set screws all the way in. 

 
2.   

Remove the outside bolts from the clutch assembly and replace the clutch 
linings. 

 
3.   

When re-tightening the bolts, stop when the clutch spacer starts to touch the 
clutch plates.  You should be able to just move the spacer by hand when you 
have the correct bolt torque. 

 
4.   

Engage clutch by turning out set screws after assembly is complete.