Brocade Communications Systems Upgrade Pef IPMC5000PEF IPMC5000PEF Manual De Usuario

         |Address        |    |   |Address            Port|Thr|Boundary |       | 

Prio | Interval

---------+---------------+----+---+-----------------------+---+---------+-------

+------+---------+

   e1/1/7 30.0.0.1        SM   Ena Itself                    1 None      default 

1        3000ms

Total Number of Interfaces : 1 

Syntax: show ip pim [vrf vrf-name ] interface [ethernet port-number | loopback num | ve num |
tunnel num ]

The vrf keyword allows you to display multicast boundary information for the VRF instance identified by
the vrf-name variable.

The ethernet parameter specifies the physical port.

The loopback parameter specifies the loopback port.

The veparameter specifies a virtual interface.

The tunnel parameter specifies a GRE tunnel interface that is being configured. The GRE tunnel
interface is enabled under the device PIM configuration.

The following table describes the output from the show ip pim interface ethernet command.

Interface

Name of the interface.

Local Address

IP address of the interface.

Mode

PIM mode, dense or sparse..

St

PIM status for this interface, enabled or disabled.

Designated Router Address, Port Address, port number of the designated router.

TTL Thr

Time to live threshold. Multicast packets with TTL less than this threshold value
are not be forwarded on this interface.

Multicast Boundary

Multicast boundary ACL, if one exists.

VRF

Name of the VRF.

DR Prio

Designated router priority assigned to this inerface.

Override Interval

Effective override interval in milliseconds.

PIM Dense

NOTE
This section describes the "dense" mode of PIM, described in RFC 3973. Refer to 

95 for information about PIM Sparse.

PIM Dense