Britax ROUND ABOUT 50 Manual De Usuario

Child Seat Functions

Storing the LATCH Connectors

When the LATCH connectors are not in use, lift

the child seat cover to access LATCH storage

slots (Fig. A). Fold each end of the LATCH

strap and slide each LATCH connector into the

adjacent slots.

NOTE:

Britax child seats are shipped with LATCH

connectors in the storage slots.

Recline Adjustment

Pull the recline handle then slide the child seat

shell into the desired position. (Fig. B) Release

the recline handle and verify the child seat has

locked into position.

NOTE:

If installed it will be necessary to loosen

the tether, vehicle seat belt, and/or LATCH strap

before adjusting the recline position. The tether,

vehicle seat belt, and/or LATCH strap must be properly re-tightened after

adjusting the recline position.

Using the Locking Clip

Install child seat into vehicle using instruction

through step 5 on pages 16-21 for rear-facing,

or pages 22-27 for forward-facing.

NOTE:

Clip is attached and stored on the back

of the seat.

Push the child seat firmly into the vehicle

seat while removing all slack first from the

lap portion of the vehicle belt, and then the

shoulder portion of the vehicle belt (Fig. A).

Hold the lap and shoulders belts together

just behind the latch plate and unbuckle the

vehicle belt without allowing the belt to slip

(Fig. A).

While holding the belts and latch plate,

thread the locking clip onto the seat belt

(Fig. B) and slide it into place near the latch

plate (Fig. C).

Buckle the seat belt with the locking clip in

place.

Verify that the seat belt is tight and the child

seat is secure.

The child seat is secure when it cannot be

•

moved front-to-back or side-to-side more than

1 inch (2.5 cm.) at the belt path. If the child seat

is not secure, repeat the installation process or

use an alternate seating location.

IMPORTANT:

Remove the locking clip from the

vehicle seat belt when not used with this child seat,

or the vehicle seat belt will not properly restrain a

passenger.

WARNING!

Child seat must be in the

full upright position when installed in forward-

facing mode with children over 33 lbs (15.1 kg).

Locking

Clip

Latch Plate