Britax Multi-Tech BB0-702-00 Folleto

Open both lock-offs. Pull off suffi cient lap 
and diagonal belt (

).

Feed the belt through the lock-off belt 
guide on the opposite side to the buckle 
and in to the belt tunnel 

. There 

are two access slots in the seat cover to 
aid feeding of the belt through the belt 
tunnel and underneath the seat cover 

.

Feed the seat belt through the belt tunnel 
and lock-off on the opposite side and 
attach the tongue into the buckle 

.

 - The child seat 

MUST

 only be used with a lap or a lap and 

diagonal seat belt (approved to UN/ECE regulation no. 16 or equivalent 
standards).

With the footprop adjusted to the shortest length, place the child seat rearward 
facing on the car seat with the swinging base resting against the back of the 
vehicle seat. After installation the gap between the seat in front and the child 
seat should ideally be a minimum of 10mm 

.

The child seat can touch the seat in front but must not rest against it. If it does 
then adjust the car seat in the front without making the driver or passenger sit 
in an uncomfortable position. If not try another seating position in the car.

Pull all the seat belt slack through the child seat ensuring the seat belt is not 
twisted. When the belt is as tight as possible, close the lock-off on the seat belt 
buckle side, ensuring that both the lap and diagonal sections of the belt are 
secured by it 

.

Close the lock-off on the opposite side, ensuring that only the lap section of the 
belt is secured by it 

.

Ensure that both lock-offs have been clicked into place.

If the buckle now lies in the position marked as wrong with a 

 and the seat 

belt cannot be correctly tightened 

, try another seating position in the 

car.

Britax_2h.indb   8

30/10/2007   16:23:52