Britax Boulevard Manual De Usuario

Release

Button

Top

Figure A illustrates a typical rear-facing LATCH

installation.

Verify that your vehicle is equipped with LATCH

anchors. If LATCH anchors are not available, you must

use vehicle belt installation methods.

NOTE:

LATCH connectors must be in an upright

position (as shown in figure B) and strap should be

tight and not twisted to ensure proper installation.

If stored, remove LATCH connectors from storage

slots under cover (see page 28).

Press and hold first LATCH adjuster button,

then pull LATCH strap to full length. Repeat for

remaining LATCH connector.

Fully recline restraint then place it sideways on

vehicle seat with front facing toward you.

Verify LATCH strap is not twisted, then attach

closest LATCH connector to vehicle seat back to

farthest LATCH anchor from you (fig. C).

NOTE:

It may be necessary to switch LATCH

connectors as shown on page 27 if ANY of the

following conditions exist:

LATCH connector is not in an upright position as

shown in figure B.

LATCH strap is twisted.

A positive click is NOT heard when LATCH connector

and LATCH anchor are connected.

NOTE:

If a positive click is not heard, but LATCH

connector is in an upright position, you should not

switch LATCH connector. The strap may be too

tight or twisted, or there may be debris in LATCH

connector.

Rotate seat into rear-facing position.

Verify LATCH strap is not twisted, then attach

remaining LATCH connector to adjacent LATCH anchor (fig. D).

•

1�

2�

3�

4�

•

5�

6�

LATCH Installation

Installation: Rear Facing