Brother PJ663 PocketJet 6 Plus with Bluetooth Guía De Instalación Rápida

a

Open the battery cover by pressing the 
cover latch.

 

b

Swing the cover open and remove it.

c

Gently insert the battery connector into 
the terminal on the inside of the battery 
compartment.

 

d

Grasp the battery removal ribbon, which 
is attached to the inside of the battery 
compartment. Make sure that enough 
ribbon is exposed after the rechargeable 
Ni-MH battery installed so that you can 
pull the ribbon to remove the battery.

e

While holding onto the ribbon, tilt the 
rechargeable Ni-MH battery and insert it 
into the battery compartment. After the 
rechargeable Ni-MH battery passes the 
outer edges of the compartment, press it 
securely into position.

• Make sure that the side of the 

rechargeable Ni-MH battery marked 
“Ni-MH” faces away from the battery 
compartment, otherwise the battery cover 
will not close properly.

• The rechargeable Ni-MH battery contains 

a heat sensor that stops the flow of 
electricity if the battery overheats.

 

f

Attach the battery cover to the end of the 
battery compartment opposite the 
AC/DC connector. Close and latch the 
cover. If necessary, gently push the 
cover latch towards the AC/DC 
connector until it latches.

• Be careful that you do not pinch the 

battery connector cord.

• The voltage supplied by the rechargeable 

Ni-MH battery fluctuates. The printing 
speed may also fluctuate depending on 
the voltage.

 

2

1

4

3