Brother S-7000DD Manual De Usuario

 

 

S-7000DD 

6

 

Do not connect the power cord until lubrication has been completed, otherwise the machine may operate if the 
treadle is depressed by mistake, which could result in injury. 

Be sure to wear protective goggles and gloves when handling the lubricating oil, so that it does not get into your 
eyes or onto your skin. 
If care is not taken, inflammation can result. Furthermore, do not drink the lubricating oil. Diarrhea or vomiting may 
result. 
Keep the oil out of the reach of children. 

When cutting the nozzle of the oil tank, hold the base of the nozzle securely. 
If you hold the end of the nozzle, injury from the scissors may result. 

 

The sewing machine should always be lubricated and the oil 
supply replenished before it is used for the first time, and also 
after long periods of non-use. 

1. Hold the base of the nozzle of the accessory oil tank (1), 

and use scissors to cut about half-way along the straight 
section (A) of the nozzle. 

2. Loosen and remove the nozzle, and then remove the seal 

(2). 

3. Tighten the nozzle. 
4. Tilt back the machine head. 
5. Remove the rubber cap (3), and pour lubricating oil into 

the oil tank (4) until it reaches the upper reference line (5). 
(Approx. 150 ml) 

6. Replace the rubber cap (3). 
7. Return the machine head to its original position. 

 

When the machine head is tilted back at times such as the 
following, lubricating oil may leak out from the oil pan (6).   
1) If the machine head is tilted back immediately after 

sewing; 

2)  If the machine head is tilted back a long way when the 

head rest has been removed; 

3)  If lubricating oil is added until the oil level goes above 

the upper reference line (5) on the oil tank (4). 

 

 

If the oil level drops below the lower reference line (7) on the 

oil tank (4), be sure to replenish the oil. 

 
 
 

 
 
 
 
 

0483D