Brother S-7000DD Manual De Usuario

 

 

S-7000DD 

27 

 

 

Replacement of parts should only be carried out by a qualified technician. 
 
Turn off the power switch and disconnect the power cord from the wall outlet before replacing any parts, otherwise 
the machine may operate if the treadle is pressed by mistake, which could result in injury. 
When replacing parts and installing optional accessories, be sure to use only genuine Brother parts. 
Brother will not be held responsible for any accidents or problems resulting from the use of non-genuine parts. 

1.  Tilt back the machine head. 
2. Remove the screw (1), and then remove the rotary hook 

stopper (2). 

3. Remove the screw (3), and then remove the fixed knife 

(4). 

 
NOTE: 

 

Carry out the above steps in reverse to install the fixed 
knife (4). 
 
 
 
 

0541D

If the cutting performance deteriorates, sharpen the fixed 
knife (4) on a whetstone (5) as shown in the illustration. 

 
 
 

2310M

 
 

1.  Remove the needle. 
2.  Lift up the presser foot using the lifting lever. 
3. Remove the two screws (1), and then remove the needle 

plate (2). 

4. Turn the machine pulley to raise the needle bar to its 

highest position. 

5.  Tilt back the machine head. 
6. Push the thread trimmer connecting rod (3) in the 

direction of the arrow until the two screws (4) can be 
seen. 

7. Remove the two screws (4), and then remove the 

movable knife (5). 

 

Carry out the above steps in reverse to install the 
movable knife (5). 

 

 

 

 

 

 

3889M

0542D