White Outdoor RB-530 Manual De Usuario

6

•

Place the hex opening of the hex nut retainer 
bracket over the flange nut securing the handle 
adjustment lock and install the lock nut on the lower 
shoulder bolt. See Figure 4.

•

Pivot handle assembly into the highest position 
possible. Tighten the bottom bolt and nut securely. 
Tighten the handle adjustment lock.

•

Remove the T-handle, nut, hairpin clip, flat washer 
and rubber washer from the end of the gear shift 
rod. Slide the rod up through the bracket on the 
front of the handle assembly. See Figure 5.

•

Insert the end of the gear shift rod through the 
opening in the top of the shift cover, and into the 
shift bracket. Secure with rubber washer first, then 
flat washer and hairpin clip. See Figure 6.

•

Install the nut and T-handle on the gear shift rod.

•

Route the clutch cable underneath the handle and 
through the cable clip. Be careful not to bend or 
kink the cable. See Figure 7.

•

Remove one hex nut from the threaded casing on 
the end of the cable and slip the wire up through the 
slot on the cable bracket underneath the handle. 
See Figure 8.

•

Push the end of the casing up through the cable 
bracket. Rethread the hex nut on the end of the 
cable. Do not tighten at this time.

•

Pull the cable upwards to obtain slack and from 
right to left hook the “Z” end of the cable into the 
bracket on the clutch control (beneath the handle 
panel). Tighten the nut against the cable bracket.
See Figure 8.