Whirlpool Conservator CAWX629JQ1 Manual De Usuario

Replace inlet hoses after five years of use to reduce the risk of 
hose failure. Periodically inspect and replace inlet hoses if 
bulges, kinks, cuts, wear or leaks are found. 

When replacing your inlet hoses, mark the date of replacement 
on the label with a permanent marker. 

Install and store your washer where it will not freeze. Because 
some water may stay in the hoses, freezing can damage your 
washer. If storing or moving your washer during freezing weather, 
winterize it.

Operate your washer only when you are at home. If you will be on 
vacation or not using your washer for an extended period of time, 
you should:

■

Unplug washer or disconnect power.

■

Turn off the water supply to the washer. This helps avoid 
accidental flooding (due to a water pressure surge) while you 
are away.

1. Shut off both water faucets.

2. Disconnect and drain water inlet hoses.

3. Put 1 quart (1 L) of R.V.-type antifreeze in the basket.

4. Run washer on a drain and spin setting (see “Drain and Spin”) 

for about 30 seconds to mix the antifreeze and water.

5. Unplug washer or disconnect power.

1. Flush water pipes and hoses.

2. Reconnect water inlet hoses.

3. Turn on both water faucets.

4. Plug in washer or reconnect power.

5. Run the washer through a complete cycle with 1 cup (250 mL) 

of detergent to clean out antifreeze.

■

Check the following:
Is the power cord plugged into a grounded 3 prong outlet?

Is the indicator on the Cycle Control knob properly lined up 
with a cycle? Turn the Cycle Control knob to the right slightly 
and pull to start.

Are the water inlet valve screens clogged?

Are both the hot and cold water faucets turned on?

Is the water inlet hose kinked?

■

Does the water level seem too low, or does the washer 
appear to not fill completely?
The top of the agitator is much higher than the highest water 
level. This creates a perception that the washer is not filling 
completely. This is normal.

■

Check the following:
Is the power cord plugged into a grounded 3 prong outlet?

Is the indicator on the Cycle Control knob properly lined up 
with a cycle? Turn the Cycle Control knob to the right slightly 
and pull to start.

Are the water inlet valve screens clogged?

Are both the hot and cold water faucets turned on?

Is the water inlet hose kinked?

■

Is there power at the plug?
Check your electrical source or call an electrician.

■

Has a fuse blown or is the circuit breaker open?
If problem continues, call an electrician.

■

Are you using an extension cord?
Do not use an extension cord.

■

Is the washer overloaded?
Wash smaller loads.

■

Is the washer in a normal pause in the Permanent Press 
(or Delicates) cycle?
The washer pauses for about 2 minutes in the Permanent 
Press cycle. Allow the cycle to continue.

The Delicates cycle (on some models) features periods of 
agitation and soak.

■

Is the washer overloaded?
Wash smaller loads.