Bunn VP17 Series Guía De Operación

Page 11

10860  061501

P1161.40

FIG. 4 LIMIT THERMOSTAT

Location:

 

The limit thermostat is located inside the rear of

the hood on the tank lid.

Test Procedures:

1.  Disconnect the brewer from the power source.

2.  Disconnect the blue and black wires from the limit 

thermostat.

3.  With an ohmmeter, check for continuity across 

the limit thermostat terminals.

If continuity is present as described, the limit thermostat 

is operating properly.

If continuity is not present as described, replace the 

limit thermostat.

Removal and Replacement:

1.  Remove  all  wires  from  limit  thermostat  termi-

nals.

2.  Carefully slide the limit thermostat out from under 

the retaining clip and remove limit thermostat.

3.  Carefully slide the new limit thermostat into the 

retaining clip.

4.  Refer to Fig. 5 when reconnecting the wires.

P1800

BLK to Terminal Block or Tank Heater Switch

BLU to BLU Lead from 

Control Thermostat

FIG. 5 LIMIT THERMOSTAT TERMINALS