Brother P-TOUCH PRO DX PT-9200DX Manual De Usuario
6
Installing P-touch Editor
Before labels can be printed on the PT-9200DX, the P-touch Editor software and the PT-9200DX printer driver must be
installed.
installed.
P-touch Editor & Printer Driver Installation (for Windows
®
95/98/Me/NT 4.0/2000 Professional/XP)
Install P-touch Editor Version 3.1 and the printer driver on a PC as described below.
Check that your system configuration meets the following requirements.
Computer: IBM PC or compatible
Operating system:
Serial interface: PC equipped with an x86 processor and a serial (RS-232C) port, and running Microsoft
Windows
®
95/98/Me/2000 Professional/XP or Windows
®
NT 4.0
USB interface:
PC equipped with a USB port, and pre-installed with Microsoft
®
Windows
®
98/Me/2000
Professional/XP
Some PCs pre-installed with Microsoft
®
Windows
®
95/NT 4.0 do not support all USB hardware features.
Hard disk free space: At least 20 MB
A few hundred megabytes of additional free space may be needed when printing long labels or large amounts of
A few hundred megabytes of additional free space may be needed when printing long labels or large amounts of
data.
Monitor: VGA or higher graphics card
Port: Serial or USB
Available memory: Minimum 32 MB
CD-ROM drive
Port: Serial or USB
Available memory: Minimum 32 MB
CD-ROM drive
Installing P-touch Editor Version 3.1
For a serial connection: Before installing the P-touch Editor software and the printer driver, connect the PT-
9200DX to the computer as described on page 4, and then turn them on.
For a USB connection: Do not connect the PT-9200DX to the computer before installing the P-touch Editor
software, otherwise it may not be installed correctly. Be sure not to connect the PT-9200DX until you are
instructed to do so.
software, otherwise it may not be installed correctly. Be sure not to connect the PT-9200DX until you are
instructed to do so.
For W
indows
®
1 Insert the P-touch Editor Version 3.1 CD-ROM into
the computer’s CD-ROM drive. A dialog box appears,
allowing you to select what to install.
allowing you to select what to install.
If the dialog box does not automatically appear, click
“My Computer” on the desktop, and then double-
click the CD-ROM drive containing the CD-ROM.
(For Windows
“My Computer” on the desktop, and then double-
click the CD-ROM drive containing the CD-ROM.
(For Windows
®
XP, click “My Computer” in the Start
menu, and then double-click the CD-ROM drive
containing the CD-ROM.)
Next, double-click “Setup.exe” to display the dialog
box.
containing the CD-ROM.)
Next, double-click “Setup.exe” to display the dialog
box.
2 Click the top button (Editor). A dialog box appears,
allowing you to select the model.
To install just the printer driver, click the lower
To install just the printer driver, click the lower
button (Printer driver).