Waterford Appliances Ceramic Hob Manual De Usuario
Voltage:
230V ~ 50Hz
Max Power:
6500W (28.3 Amps)
Plate Ratings:-
Rear Left Hotplate:
Rear Left Hotplate:
O 145mm - 1200W
Rear Right Hotplate: O 180mm - 1800W
Front Left Hotplate:
Front Left Hotplate:
O 210mm - 2300W
Front Right Hotplate: O 145mm - 1200W
Dimensions: 581mm x 513mm x 48mm
Weight:
8Kg
Complies To: EN 60335 - 1 & EN 60335-2-6
Before selecting a position to install the hob, the
following must be considered:
following must be considered:
* Do not install the hob near refrigerating
devices.
* Do not fit the hob over a cooker without a
cooling fan, dishwasher, refrigerator, freezer
or washing machine.
or washing machine.
* The worktop the hob is fitted into should be
resistant to temperatures up to 100
o
C. This
applies to the veneer, plastic surfaces, glues
and varnishes.
and varnishes.
* When installing the electric supply to the hob,
ensure that the cable does not touch any hot
parts of the hob or other units around it.
parts of the hob or other units around it.
* Once installed the clearances around the hob
should be as detailed in Fig.1, when fitted on
work top over a carrying cupboard or Fig.2
when fitted on a work top over a ventilated oven.
work top over a carrying cupboard or Fig.2
when fitted on a work top over a ventilated oven.
TECHNICAL INFORMATION
INSTALLATION
POSITIONING & FITTING THE HOB
Fig. 1
Fig. 2
1. Cut out a square opening in the work top, as
shown in Fig.3, with a minimum of 60mm of the
work top behind the opening.
work top behind the opening.
2. Sit the hob into the cut-out on the worktop.
3. Fit the tension brackets loosely and then with
the hob centered tighten all the tension brackets
evenly starting in the centre and moving diago-
nally. (see Fig.4) Fill the gap between the hob
& worktop with a silicone sealer if required.
evenly starting in the centre and moving diago-
nally. (see Fig.4) Fill the gap between the hob
& worktop with a silicone sealer if required.
Fig. 3
4
513
581
Fig. 4
Worktop
Bracket
Seal
Ceramic
483
555