Woodstock System W1827 Manual De Usuario

-42-

To reduce the risk of kickbacks and to increase the 
quality of cuts, it is important that the table and spindle 
are perpendicular to each other in all directions. Use 
a machinist's square or other precision square when 
checking/adjusting these components to ensure accurate 
results (see 

=`^li\j,-,.).

(%  DISCONNECT SHAPER POWER!

)%  Remove the guard and fence assembly.

*%  Raise the spindle all the way up.

+%  Remove the locking fasteners, spacers, and cutters 

from the spindle.

,%  Position a machinist square flat on the table and 

up against the spindle (see 

=`^li\,-) and in 

all directions (see 

=`^li\,.)—the spindle and 

table should be perpendicular to each other in all 
directions.

— If spindle and table are not perpendicular to each 

other in all directions, do these steps:

X% Loosen the four table adjustment bolts (see 

=`^li\,/) enough so that the table can be 
adjusted.

Y%  Use a dead blow hammer to tap the table into 

proper alignment with the spindle.

Z%  Re-tighten the four table adjustment bolts.

[% Repeat this Jk\guntil the spindle and 

table are perpendicular to each other in all 
directions.

=ifekf]KXYc\

Jg`e[c\

0'—

DXZ_`e`jk

JhlXi\

=`^li\,-% Illustration of using a machinist 

square with the table and spindle.

DXZ_`e`jk

JhlXi\

Jg`e[c\

=`^li\,.% Illustration of machinist square 

at different directions around the spindle.

=`^li\,/% Table adjusting bolt

(1 of 4).

Table Adjustment

Bolt (1 of 4)