Woodstock 52" FOOT SHEAR M1044 Manual De Usuario
-10-
M1044 52" Foot Shear
SE
T
U
P
You will need the help of an assistant for this step.
To install the foot pedal as shown in Figure 5, do these
steps:
1. Loosen the set screws that hold the hinge pins in
place and slide them outward.
2. With the help of an assistant, position the foot
pedal pivot over the hinge pin hole and insert the
hinge pin.
3. Tighten the set screws to hold the hinge pin in posi-
tion.
4. Link the two swivel bottoms through the side arms
of the foot pedal with the supplied bolts and tighten
in position.
5. When complete, the finished assembly should look
like
Figure 5.
Foot Pedal
OFF Button
Main Power
Switch
To install the front extension arms as shown in Figure
6, do these steps:
1. Loosen the 19mm bolts on the front of the table.
2. Place the front extension arms over the bolt and
behind the special washers.
3. Line up the channel of the front extension arm with
the channel on the table.
4. Make sure the ground surface on the front extension
arm is flush with the top of the table surface.
5. Tighten the bolts and check to make sure your align-
ments are still intact. If they are not, readjust.
6. When complete, the finished assembly should look
like
Figure 6.
Front Extension Arms
Swivel Bottom
Hinge Pin
Pedal Pivot
Set Screw
Figure 6. Front extension arm installed.
Figure 5. Foot pedal assembly.
Front Extension Arm