Wiebetech I Manual De Usuario

 
 

 

  Install your hard drive into the tray.  Unlock the tray by using the plastic key.  Slide the tray out of 

the outer casing.  Remove the plastic spacer.  Lay the drive into the frame of the removable tray, making 
sure it lays flat.  Align the 4 screw positions then use the included screws (#6-32) to secure the drive into 
position.   

 

 

  Insert the tray into the SilverSATA I unit.  Gently push the tray along the sliding track into the hard 

drive compartment and then close the tray, as shown below. 

 

 
 
 
 
 
 
 
 
 

 Mount SilverSATA I Internal in your computer.  In an open 5 ¼” bay in your computer, install 

SilverSATA I Internal just as you would a CD/DVD ROM. 

  Plug in the data cable.  The SilverSATA I Internal connects to your 

computer through SATA.  One end of the cable connects to the back of 
the unit.  Insert the other end into an available port on your computer’s motherboard or add-in card. 
 
 
 
 

  Plug in the power.  Take an unused Molex 4-wire power connector 

from inside your computer and plug that into the back of SilverSATA I 
Internal. If your drive is already formatted, you can begin using the unit 
right away.  New hard drives will need to be formatted before they can 
be used.