Southbend SOUTH BEND LATHE CO.. SB1024 Manual De Usuario

For Machines Mfg. Since 8/09

SB1024/SB1025/SB1026

-47-

 

Select one of the three downfeed rates 
by pulling the knob of the auto-downfeed 
rate selector out, position the selector over 
the appropriate detent, then release the 
knob. Make sure the pin is firmly seated 
by attempting to move the selector without 
pulling the knob out.

 Refer to the illustration in Figure 43 when 

selecting the downfeed rate.

  Use the coarse downfeed lever to lower the 

spindle slightly until you can pull the clutch 
lever out to the left and it locks in place, 
which will start the auto-downfeed spindle 
travel.

H = 0.006 in./rev.
L = 0.0015 in./rev.
M = 0.003 in./rev.

(Rates given in inches of travel

per revolution of the spindle)

After turning the power to the spindle OFF, 
move the brake lever back or forth to bring the 
spindle to a full stop (see Figures 44–45).

To evenly wear the brake shoes, alternate the 
direction you move the lever when braking.