Harbor Freight Tools 66305 Manual De Usuario

Page 5

SKU 66305

Do not attempt to manually raise or 

9. 

lower the Lift. Operate the Lift hy-

draulically only as described in this 

manual only.
Do not leave Lift unattended with a mo-

10. 

torcycle on it. The Lift is not for long term 

storage.
Do not leave any load on the Lift for 

11. 

an extended period of time. This Lift is 

not designed as a storage device. Re-

move motorcycle from Lift immediately 

after completing service operation. 
Use only on firm, level unobstructed 

12. 

surface able to support the weight 

of the Lift, the vehicle, and any tools 

that will be located in the work area.
Do not use Lift to move the motor-

13. 

cycle. This Lift is designed to lift the 

motorcycle in place only.
Whenever a motorcycle is lifted, the 

14. 

Safety Bar (75) must be engaged 

immediately before any further steps 

are taken.
Do not use Lift for any aircraft purpose.

15. 

For indoor use only.

16. 

Do not ride on this Lift. Do not ride on 

17. 

the motorcycle as it is lifted. Riding 

on Lift may cause personal injury.
Always control the speed of a loaded 

18. 

lift.  It must raise or lower slowly 

when loaded. Never attempt to lower 

the Lift when loaded by using the 

yellow No Load Pedal (71). The No 

Load Pedal is only used to lower the 

Lift when it is not loaded.
Do not lower the motorcycle quickly. 

19. 

Only use the Load Pedal (69) to 

slowly lower the Lift when there is a 

motorcycle on it. NEVER allow the 

vehicle to drop suddenly.
The warnings and precautions dis-

20. 

cussed in this manual cannot cover 

all possible conditions and situations 

that may occur.  It must be under-

stood by the operator that common 

sense and caution are factors which 

cannot be built into this product, but 

must be supplied by the operator. 

Failure to comply with these warn-

ings may result in injury or damage to 

property.

The Lift comes completely assembled, 

except for the following items: (Refer to 

the exploded drawing).

The two front tie 

downs are longer than the rear pair. 

Slide the front tie downs (13) onto the 

rods welded at either side of the front 

end of the platform, and secure them 

with bolts (14) and nuts (15). Attach 

the shorter rear tie-downs (31) to the 

rear rods and secure with bolts (14) 

and nuts (15).

Place the wheel 

chock (17) on to the front end of the 

platform and align it with a suitable 

pair of holes. Slide the long bolt (19) 

through a hole in the side of the 

platform and through the sleeves 

welded to the back of the chock and 

out the other side of the platform. 

Secure with nut (18).

Drop the 

ends of the ‘U’ shaped front wheel