Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Harbor Freight Tools
  4. 18 Volt 1/2 in. Cordless Variable Speed Hammer Drill with Keyless Chuck
  5. Manual Del Producto

Harbor Freight Tools 18 Volt 1/2 in. Cordless Variable Speed Hammer Drill with Keyless Chuck Manual Del Producto

Descargar
Página de 12
Page 6
For technical questions, please call 1-800-444-3353.
Item 68851 
        
Grounding
to pRevent eleCtRiC ShoCK and death  
FRom inCoRReCt GRoundinG WiRe ConneCtion: 
Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.  
do not modify the power cord plug provided with the Charger.  do not use the Charger if the power 
cord or plug is damaged.  if damaged, have it repaired by a service facility before use.  if the plug will not fit 
the outlet, have a proper outlet installed by a qualified electrician.
double insulated tools: tools with two prong plugs
outlets for 2-prong plug
1.  Tools marked “Double Insulated” do not 
require grounding.  They have a special 
double insulation system which satisfies 
OSHA requirements and complies with 
the applicable standards of Underwriters 
Laboratories, Inc., the Canadian Standard 
Association, and the National Electrical Code.
2.  Double insulated tools may be used in either of the 
120 volt outlets shown in the preceding illustration.
   
(See outlets for 2-prong plug.)
extension Cords
note:  Extension cords must not be used with this item’s Charger.
Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
v~
Volts Alternating Current
a
Amperes
n0 xxxx/min.
No Load Revolutions per Minute (RPM)
WARNING marking concerning Risk 
of Eye Injury.  Wear ANSI-approved 
safety goggles with side shields.
Read the manual before 
set-up and/or use.
WARNING marking concerning 
Risk of Hearing Loss.  
Wear hearing protection.
WARNING marking 
concerning Risk of Fire.  
Do not cover Charger ventilation ducts.
Charge on fireproof surface only.
WARNING marking concerning 
Risk of Electric Shock.  
Properly connect Charger’s power 
cord to appropriate outlet.
WARNING marking concerning 
Risk of Explosion.  
Do not puncture, short, or open 
battery packs and do not charge 
damaged battery packs.
Sa
Fet
Y
o
pe
R
ation
m
aintenan
C
e
Setup