Cavalry Storage CADA-U3E4 Manual De Usuario

CADA4-U3E

7

2

Important: To set any RAID mode, you have to first reset the mode back to the JBOD setting. Follow the 

directions below to set all mode settings: JBOD, RAID 0, RAID 1+0, RAID 3, RAID 5, Clone, and Combine 

modes.

Install your hard drives. Plug the CADA-U3E4 into a power source with the included power supply. Next, 

connect the CADA-U3E4 into your computer via USB 3.0/2.0 or eSATA cable. 

Do not power on your unit just yet.

Set the desired mode setting show to the right of this quick start guide under “Mode Settings.”

Hold the “reset” button down and continue to hold the “reset” button while you power on the unit. Sustain 

the hold for 10 to 15 seconds thereafter and let go of the “reset” button.

Your 

CADA-U3E4

’s settings will now be set with the setting you chose in Step 2. To verify, check your drives 

in your computer’s Disk Management Utility.

1

2

3

4

DIP ON

1

2

3

4

DIP ON

1

2

3

4

DIP ON

1

2

3

4

DIP ON

1

2

3

4

DIP ON

1

2

3

4

DIP ON

1

2

3

4

DIP ON

Once you have created your new array, you will need to ‘Initialize’ it before it will be accessible to your 

OS. This involves partitioning and formatting your new RAID volume. This can be done using the Disk 

Management Utility of your OS (see pg. 9).

 Clone mode and Combine mode are disabled at the time of this writing. Do Not Apply these modes. Please 

go to CavalryStorage.com for the latest firmware update before attempting to use clone or combine modes.