Viewsonic V35 Manual De Usuario
ViewSonic Pocket PC V35
3
2
Setting the Battery Switch
The switch on the back of your Pocket PC V35 should be switched to the ON
(down) position. If this is not the case, please set it to ON.
1
Make sure that theV35 is turned off.
2
Unscrew the rear cap of your stylus. Use the pointed end of the cap to slide
the battery switch to the ON (down) position.
the battery switch to the ON (down) position.
3
The Notification indicator will flash red for approximately 30 seconds, and
then your V35 will automatically turn on and display the Welcome Wizard
then your V35 will automatically turn on and display the Welcome Wizard
screen.
IMPORTANT: Keep the battery switch set to ON (down position) unless
you need to restore factory defaults.
3
Charging the Battery
Connect your V35 to an AC power source.
Plug the V35 into the USB cradle.
NOTE: You can also connect the V35 directly to the AC adapter without using
the USB cradle. For more information see “Battery Charging Options” in this
chapter.
Plug the appropriate end of the AC adapter into the power connector on the
USB cable.
NOTE: For information about battery replacement, see page 80.
1
2
V35_UG.book Page 3 Monday, October 28, 2002 4:56 PM