Universal URC-SR3 Manual De Usuario
Page 23
OSD (On-Screen Display) Control “Punch
Through”
This “Punch Through” enables you to program the
URC-SR3 so that CBL/SAT or DVD/DVR/VCR
OSD Controls (GUIDE, MENU, INFO, EXIT, My
Button, Sel and 4 Cursor Controls) will also operate
in other component modes on the remote control.
STEP 1: Press and hold the component button you
want to add OSD Control to, such as TV or DVD,
and the SELECT [SEL] button at the same time for
two seconds until the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the MENU button. The component
LED will blink once.
Through”
This “Punch Through” enables you to program the
URC-SR3 so that CBL/SAT or DVD/DVR/VCR
OSD Controls (GUIDE, MENU, INFO, EXIT, My
Button, Sel and 4 Cursor Controls) will also operate
in other component modes on the remote control.
STEP 1: Press and hold the component button you
want to add OSD Control to, such as TV or DVD,
and the SELECT [SEL] button at the same time for
two seconds until the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the MENU button. The component
LED will blink once.
STEP 3: Press either the CBL/SAT or DVD button
that you want to use as the source of OSD Control.
The component LED will blink two times to confirm it
is saved.
that you want to use as the source of OSD Control.
The component LED will blink two times to confirm it
is saved.
SELECT
MENU
COMPONENT
BUTTONS