Universal CONTROL WR7 Manual De Usuario
Page 30
Erasing Commands - Overview
You can erase a single learned command, all learned
commands in each component mode, SimpleSound programming,
MacroPower commands, or re--set the remote to original factory
default settings.
commands in each component mode, SimpleSound programming,
MacroPower commands, or re--set the remote to original factory
default settings.
Erasing a Single Learned Command from
One Component
One Component
STEP 1:
Press the component button where the learned com-
mand is stored and the [ENTER] button at the same time for two
seconds until the component LED light turns on.
seconds until the component LED light turns on.
IMPORTANT:
You have 30 seconds to perform the next
step while you are in programming mode. If you do not press a
button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have
to start over.
button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have
to start over.
STEP 2:
Press and hold the button you want to erase for two
seconds. The component LED light will blink twice to confirm
the erasure.
the erasure.
STEP 3:
Repeat Step 2 to erase any other buttons in the selected
component mode.
STEP 4:
To exit Erase mode, press and hold both the component
button and the [ENTER] button at the same time until the compo-
nent LED light blinks three times.
nent LED light blinks three times.
COMPONENT
BUTTONS
ENTER
WR7 1/13/08 12:18 PM Page 30