Universal R-320 Manual De Usuario

 

8.  Stop conveyor by turning speed control to “O”.  Turn off turning unit.  Plug power  

 

     cord of applier into control box on front of conveyor.  (NOTE:  Applier and turning  

 

     unit will not receive power with switch on control box on front of conveyor in OFF  

 

     position).     

 

9.  Raise or lower applier so that label is centered on container.  Label web must always  

 

     run to lower edge of peeler bar on this system, with edge of peeler bar clearing top of  

 

     conveyor EDGE.   DO NOT LOWER APPLIER TO THE POINT WHERE EDGE  

    

 

     OF PEELER BAR IS RESTING ON TOP OF CONVEYOR EDGE. 

          10.  Adjust peeler bar so that back side clears turning belt by no more than 1/8”. 
          11.  Turn on master switch on applier, then turn on motor switch; one label will advance. 
          12.  Product sensing micro switch is secured to edge of guide rail with arm extending  
 

     through guide rail.  Activating this switch by hand will cause applier to deliver a label.   

 

     NOTE:  Position label at end of peeler bar and adjust star wheel on applier so that 1/8” 

 

     to 1/4” of label is extending beyond peeler bar edge when label is delivered and  

 

     applier stops delivering a label.  Trigger applier head with product sensing several  

 

     times to allow web to track properly and to observe extension of label beyond peeler  

 

     bar. 

 
 

Turn on conveyor by speed control knob and adjust to just below maximum speed.  Turn on 
turning unit.  Speed control knob on applier should be set at approximately 65 on dial - - with 
turning unit at approximately the same setting. 
 
With all systems running - - Place container on conveyor and 
NOTE: 
 

1.  Point at which product switch activates relative to position of container.  The ideal  

 

     point of which the applier starts delivering the label is as the container contacts the  

 

     center line of the first pulley of the turning unit and is encapsulated between the  

 

     turning unit belt and the rubber of the guide rail.  Adjust the product sensing switch  

 

     back or forward to achieve the best results.  A little experimenting by the operator for  

 

     the optimum position is in order.  Triggering the applier too early or too late can result       

in mis-register or wrinkled labels. 
 

2.  Next in this procedure, observe that as the label is being dispensed and applied that the 

 

     speed of the applier is not causing the label to be pulled by being too slow.  (Speed up  

 

     by speed control on applier), or is delivering the label too fast as to incur wrinkling of  

 

     label on the container (slow applier by same procedure).