Sterling Home Theater Server XXX10-80 Manual De Usuario

10-Pump, 80-Station Controller           Chapter 3:  Installation 

24 

1.  Attach a KwikLink connector included in the bag with power cables to the flat 

cables. One connector is used for the network grey cable and one connector is used 
for the auxiliary power black cable. 

2.  Align the square connector of the grey drop cable so the cable leads down from the 

connector. Evenly press the square connector onto the top of the bottom KwikLink 
connector. It should make two audible snaps when properly seated. 

3.  Align the square connector of the black drop cable so the cable leads down from the 

connector. Evenly press the square connector onto the top of the upper KwikLink 
connector. It should make two separate, audible snaps when properly seated. 

4.  Attach the keyed round connectors to the receptacles on the side of the power supply 

enclosure marked 24 VDC POWER SUPPLY. Tighten the cord grip ring until 
snug. 

5.  Dress the excess cables with cable ties so they do not interfere with operation and to 

give a pleasing appearance. 

If more than one power supply is required to properly energize the grey network flat cable: 

1.  Remove the terminal block jumpers on all but the most centrally-located network 

power supply enclosures. 

For locations of jumpers, refer to the drawing shipped inside the power supply 
enclosure