Sterling Home Theater Server XXX10-80 Manual De Usuario
10-Pump, 80-Station Controller
Chapter 8: Appendix
83
4. Wait for the Run LED on the top front of the CPU to turn solid green and for the I/O LED to
stop blinking (Fig 2) for 30 seconds. Since a new CPU requires a firmware upgrade this will take
about 2-3 minutes. Do not turn off power until the upgrade completes.
about 2-3 minutes. Do not turn off power until the upgrade completes.
Fig 2
5. Turn off power to the control enclosure. Wait 5 seconds. Turn on power.
6. Wait for the I/O LED to stop blinking (Fig 2).
7. Remove the card labeled PLC Configure 744.00130.00 from the PLC CPU by pressing the
6. Wait for the I/O LED to stop blinking (Fig 2).
7. Remove the card labeled PLC Configure 744.00130.00 from the PLC CPU by pressing the
retaining clip to the right and pulling the compact flash card straight out.
8. If you have a compact flash card with your system settings save on it, insert it into the PLC CPU.
If not, skip to step #14.